What is the function of EGR valve?
What is the function of EGR valve?
It connects the exhaust manifold to the intake manifold and is controlled by either a vacuum or a built-in electric step motor. The function of the EGR valve is to control the flow of exhaust gas being recirculated depending on the engine load.
What opens the EGR valve?
When vacuum is applied to the EGR valve, it opens. This allows intake vacuum to suck exhaust into the engine. To prevent the EGR valve from opening when the engine is cold, the vacuum line to the EGR valve may be connected to a parted vacuum switch or a computer-controlled solenoid.
What is EGR PDF?
Exhaust gas recirculation (EGR) is a pre-treatment technique. This is the widely used process to reduce and control the oxides. of nitrogen (NOx) emissions from diesel engines. EGR control. the NOx because it lowers oxygen concentration and flame.
How does exhaust gas recirculation ( EGR ) work?
Exhaust Gas Recirculation (EGR) complete guide – architectures Exhaust gas recirculation (EGR) is the most common technology to reduce nitrogen oxides (NOx) emissions on diesel internal combustion engines (ICE). EGR takes exhaust gases from the exhaust manifold and reintroduces them into the intake manifold, mixing them with fresh air.
How is the position of an EGR valve determined?
The position of an EGR valve actuated by a DC motor can only be achieved by using a position sensor . The position sensor of the valve is linear and provides a signal proportional to its supply voltage (usually 5V). The EGR valve position sensor signal is set to increases in the direction of the opening of the valve.
What are the different types of EGR components?
Linear solenoids, stepper motors, torque motors and DC motors are the main types of electric actuators being used and developed by various EGR component suppliers. These offer the advantage of faster and more precise operation compared to a conventional vacuum (pneumatic) operated system.
Why is an EGR cooler needed In an oxidation catalyst?
The EGR cooler has a very high heat exchange efficiency and, without by-pass, the recirculated gases would be very cold and delay the warm-up of the oxidation catalyst, which would lead to excessive emissions of HC and CO. The solution is therefore to bypass the EGR cooler until the oxidation catalyst reaches nominal working temperature.