How much does it cost to rebuild a G56 transmission?

average cost to heal a roached G56 runs $3K.

What’s better G56 or NV5600?

The single advantage to the NV5600 is the higher OD ratio than the G56 in the pre-emission years. Some say there isn’t enough main shaft supports and the aluminum case flexes too much on the G56 when used hard. The NV5600 is heavy and requires oil changes often, IMO at 20K miles, as it shears it’s oil down.

What is a G56 Dodge?

Originally manufactured in Brazil by Mercedes-Benz, the Mercedes G56 transmission is a 6-speed manual transmission. It was designed specifically for Dodge Ram 2500 or Dodge Ram 3500 diesel trucks and light pickups. The G56 transmission was designed as a replacement for the NV5600 transmission.

How much does it cost to rebuild a NV5600?

The price for a rebuild will depend on the damage. It’s gonna start around $1500 and go up from there. If it’s running good now, just needing Synchro’s, it’s gonna run around $1500 with a bearing kit, and add around $550-650 for shipping.

How heavy is a G56 transmission?

Weight: 225 lbs. The G56 was designed as a replacement for the New Venture NV5600 5 speed. . The unit is a heavy duty synchronized unit.

What is the difference between NV3500 and NV4500?

NV3500 is light duty and aluminum with the bellhousing made as part of the case. A NV4500 has a much higher load rating, granny 1st gear, cast iron case with bolt on aluminum bell, much larger overall and has PTO ports.

What years did Chevy use the NV4500?

The NV4500 was first released in Chevy / GM trucks from 1992 under GM RPO code MT8 and GM part #12346190. It was introduced into Dodge trucks in 1995. Though it has it roots as the New Process 4500 four-speed beginning as early as 1972 in Dodge trucks, its current incarnation as we know it today is quite different.

What are the parts for a G56 transmission?

We stock a complete selection of G56 transmission and associated parts, including Dodge G56 bearings, G56 shifter parts, G56 input shafts and a total G56 transmission rebuild kit.

What kind of front bearing does a Dodge G56 use?

Front Bearing Retainer for Dodge G56 6-Speed Transmission Specifications:Material: Cast Iron Brand: Aftermarket Allows use of stock part number throwout bearing Replaces: Mopar 05166047AAPart Number: G56-6… Heavy Duty Pilot Bearing NOTE: Only Fits Flywheels Modified for HD Pilot ..

What kind of input shaft does Mercedes G56 use?

Mercedes G56 Transmissions with 1-3/8″ Input Shaft Converts the factory Dual Mass flywheel to a solid mass flywheel. WILL NOT WORK WITH A STOCK CLUTCH OR DUAL DISK CLUTCH. These are drilled to accept 13.00″ pressure plates only.Used in our G56 Solid Flywheel Conversions.

Is there a warranty on a Dodge G56?

Our factory rebuilt re-manufactured transmissions are dyno tested before leaving the factory, ensuring the highest quality, We also have New G56 transmissions in stock. We offer a no hassle 12 month warranty, performance guaranteed.