How do you adjust a prodigy 2 brake controller?

Roll the adjustment wheel on the left up or forward (towards the front of the vehicle) to get it to 6. Then you will drive about 20 miles per hour nd fully apply the manual override lever at the bottom (do not use the brake pedal). If the brakes lock up adjust the power down by turning the wheel the other way.

How do I reset my Prodigy P2?

Expert Reply: First, lets start by resetting the Prodigy P2. With the trailer disconnected from the vehicle, disconnect the brake controller by unplugging the harness from the rear of the unit, and plug it back in. The display will show NC for 15 seconds, and then show two dots.

What is PL on Prodigy brake controller?

What does that mean? asked by: Cindy J. Expert Reply: The error code P.L. on the Prodigy # 90885 trailer brake controller indicates that 12V input power has been interrupted while the brake pedal is pressed. This power is carried on the controller’s black wire.

How do you turn off Prodigy P2?

There is no way of powering the control off, short of unplugging it.

How do I know if my brake controller is bad?

Use a circuit tester, and check the red wire that exits the rear of the controller. This wire should only go hot when the brake pedal is pressed. If this checks out ok, then the controller is bad and must be replaced.

Does the Prodigy P2 turn off?

The display on the P2 will shut off automatically after 20-30 minutes of inactivity. The control will go into its sleep mode after 20-30 minutes of no brake pedal application or no manual lever activation.

How do I turn off p2 prodigy?

The control will go into its sleep mode after 20-30 minutes of no brake pedal application or no manual lever activation. At this time, the current draw will only be about 5 milliamps. There is no way of powering the control off, short of unplugging it.

How do you install a prodigy P2 trailer?

1. Connect trailer to tow vehicle. 3. side into the mounting holes. 2. 4. screws until snug. 3. surface at 25 mph and fully apply manual knob. Turn power down using power knob. Turn power up using power knob.

Which is the instruction manual for the Prodigy P2 # 90885?

I’ve linked you to a copy of the installation instructions which you can print out if you wish. I’ve also linked you to our Brake Controller FAQ article, which includes much more information about brake controllers and how they operate. I’ve linked the manual for the Prodigy P2 # 90885 . It is the pdf so you should be able to open it without issue.

What does the inertial sensor on Prodigy P2 do?

The Prodigy P2 employs an inertial sensor. It Braking”. engaged. engaged. 3. onds. 4. reverse. It will apply the appropriate brake voltage hypothetical power output. This value is set using based on deceleration. the power knob.

How does proportional braking work on a prodigy?

The Prodigy employs an inertial sensor. It senses deceleration and generates an output that is based on deceleration, thusthe term “Proportional Braking”. The Prodigy will “HOLD” your trailerwith 25% of power setting while you are at a standstill with brake pedal applied forlonger than 5 seconds.