How do I know if my toilet is a 10 or 12 rough?

If your toilet has four bolts rather than the standard two, you’ll measure to the center of the rear bolts. The standard rough-in measurements are 10, 12 and 14 inches. If your measurement is in between these intervals, round your number down to the nearest standard measurement.

How do you know what size rough-in for a toilet?

The rough-in measurement of a toilet refers to the span between the wall behind the toilet and the center of the waste pipe. To measure the rough-in for your toilet, measure from the wall behind the toilet to the middle of the bolt caps (the caps holding your toilet to the floor).

Can you replace a 10-inch rough-in toilet with a 12-inch rough-in toilet?

The rough-in for your bathroom plumbing should match the rough-in for the toilet. Even if a toilet is designed for a 10-inch rough-in, you can still install it in a space with a 12-inch rough-in.

What is the rough-in for a toilet from the wall?

12 inches
The toilet rough-in refers to the distance from the finished wall to the center of the toilet’s floor drain or waste outlet. Most toilets have a rough-in of 12 inches, although it’s not uncommon for older homes to have an unusual size such as 10″ or 14″.

Do I need a 10 or 12 inch toilet?

A 10-inch rough-in is the usual measurement installed in older homes. However, the 12-inch measurement is the standard for modern toilet plumbing. Most toilets that you encounter in retail outlets have 12-inch rough-in dimensions.

What is standard toilet size?

Standard toilet dimensions are typically between 28–30″ deep, roughly 20″ wide, between 27–32″ high, and have a rough-in between 10–14″. Now you can find the perfect toilet.

Do all toilets seats fit the same?

No, there isn’t a standard size for all toilet seats, due to a variety of toilet styles. There are key measurements that you will need, even though most seats are adjustable to fit the most common toilet bowl shapes. The measurements are: The distance between the fixing holes – where the screws are.

What’s the size of a standard toilet?

Can you replace a 14-inch rough-in toilet with a 12-inch rough-in toilet?

Replace a 14-inch rough-in toilet with a 12-inch rough-in toilet. You can definitely replace a toilet with a rough-in of 14 inches with one with a rough of 12 inches. The problem with this method is that a 2-inch gap will be left between the toilet tank and the wall.

How many inches should a toilet be from the wall?

Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.) There should be at least 24 inches of clear space in front of a toilet or bidet.

What does 10 inch Rough in toilet mean?

Measuring a 10-inch rough-in toilet is quite simple. Take some measuring tape and see how much you have from the wall to the main drain pipe. A 10-inch rough-in means that the toilet’s main drain is 10 inches away from your bathroom’s wall.

How do I measure toilet rough in?

Measure toilet rough in with existing toilet. On either side of your toilet, you’ll see two bolts (usually with caps on them). Measure from the center of those caps or bolts to the wall and that measurement is your “rough in”.

How to measure your toilets rough in?

not on the molding at the base of the wall.

What does “rough in” mean with regard to a toilet?

Toilet rough in is the measurement from the wall of the bathroom to the bolt cap of the toilet. In toilets, the rough in distance is the distance from the wall behind the toilet to the center of the toilet outlet pipe where the waste matter leaves during flushing.