How do I find my sentry safe model number?

The serial number can be found on a label adhered to the front of your unit or inside on the door. Note: Be sure to enter all of the information, including any letters preceding the number and the asterisk at the end.

Can I reprogram my sentry safe?

To reset the combination on a Sentry safe, open the door of the safe, delete the existing codes, press the PROG or P key and enter the factory code. Finally, enter a new five-digit number as per individual preference, which is the new user combination.

How do you open a Sentry safe with error?

For a sentry safe with a dial combination it is the standard turning procedure: Clear the lock, by turning the dial past 0 three times counter clockwise. After the third time, stop on the first number of the combination. Turn the dial counter clock wise and pass the second number of the combination once.

How do you reset a locked Sentry safe?

How to Reprogram a Sentry Safe

1. Press the “Prog” key on the keypad.
2. Enter the five digit pre-set factory code twice.
3. Enter a new five digit personal access code of your choice.
4. Delete the personal access code by pressing “Prog” key and entering the five digit pre-set factory code twice.

What’s the factory code for Sentry safe?

62044
Before we begin, locate the 5-digit factory code located on the back of your owner’s manual, and enter the code to open the door. This safe is set to “62044.” To program the primary-user code, press the [P] button and enter the 5-digit factory code on the electronic keypad.

How do you reset your digital safe if you forgot the code?

If you’ve forgotten your passcode, you can reset it by using a thin rod or wire to press the reset button on the inside of the door panel. If all else fails, you can try breaking open the lock or drilling through the override key slot.

What’s the factory code for Sentry Safe?

How long does sentry safe lock out?

The lock allows 5 seconds for each key press. If you pause longer, an error signal will occur (blinking red light and three beeps), indicating you should start over. There are three possible ways to unlock and access the safe—by entering its pre- set Factory Code, your own User Code or a Passcode.

Why is my safe not opening?

There are a handful of reasons your safe won’t open. As outlined above, it could be due to dead batteries, lockout mode or time delay, jammed bolt work, disconnected or damaged wiring, and deactivated code. If the safe isn’t still opening, you can call a locksmith for assistance.

https://www.youtube.com/watch?v=p8RG_ET5Tx4